Manufacturing Steps Of Lean Tube Table

1. Form an image of the lean pipe table you want to make in your mind and draw a sketch.

2. Refer to drawings, prepare materials, lean pipes, lean pipe joints and other materials, decide the type and quantity of joints, size and number of pipes.

3. Purchase the most suitable wire rod pipe after calculating. The pipe specifications include: 30cm, 45cm, 60cm, 90cm, 1.2M, 1.5M, 2M, 2.5M, 3M, 4M and other lengths.

4. Measure the size of the lean pipe and mark the cutting position with a pen.

5, although the metal cutting saw sold on the market can also cut, the cutter blade at the mark. But the manual cutter can cut vertically using specialized/industrial lean pipe.

6. Remove the burrs generated at the incision of the line rod pipe (outside to inside) with file, because burrs may scratch people. It will cause the top cover embedded inside the incision (tube inner top cover) to be difficult to embed. When cutting with wire rod tubing/manual cutters, fixing the tubing to a workbench reduces the difficulty of cutting and the blade is more durable. If the blade is defective, replace it in time.

7. Assemble and glue (assemble the lean pipe table in the following order)

8. Please install the joint on the pipe and make the first two feet. After the joint is installed in place, glue them together and make two feet.

9. Put the joint on the pipe and make the back foot (one on each side). Do not glue it first. Gluing the selected joint and joint gluing. Finally, determine the location of the joint after bonding, so that it is symmetrical, pay attention to the direction of the joint, left and right each.

10. The front foot and back foot are connected and bonded with pipes in the direction of the joint. Since the left and right sides are symmetrical, please note that when assembling, connect the front and back feet at 1 and 2 and make the left and right sides. Please assemble in a flat place to prevent the direction of the joint from rotating.

11. Finally, the 4 feet of the table are glued to the plate bearing joint, which is connected to the left and right front made in the 3 places. The right side and left side are connected with pipes and glued.

12. The lean pipe table is finished, and the panel is cut into the size of the lean pipe table and placed on the table. The lean pipe table is finished.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top